M. I. Khan, T. Yasmeen, M. I. Khan, and M. Farooq, Research progress in the development of natural gas as fuel for road vehicles: A bibliographic review, vol.66, pp.702-741, 1991.

A. Shah, S. S. Thipse, A. Tyagi, and S. D. Rairikar, Literature Review and Simulation of Dual Fuel Diesel-CNG Engines, 2011.

L. Wei and P. Geng, A review on natural gas/diesel dual fuel combustion, emissions and performance, Fuel Processing Technology, issue.142, pp.264-278, 2016.

J. Rochussen, J. Yeo, and P. Kirchen, Effect of Fueling Control Parameters on Combustion and Emissions Characteristics of Diesel-Ignited Methane Dual-Fuel Combustion, 2016.

B. Yang, C. Xi, X. Wei, and K. Zeng, Parametric investigation of natural gas port injection and diesel pilot injection on the combustion and emissions of a turbocharged common rail dual-fuel engine at low load, Applied Energy, issue.143, pp.130-137, 2015.

J. Liu, F. Yang, H. Wang, and M. Ouyang, Effects of pilot fuel quantity on the emissions characteristics of a CNG/diesel dual fuel engine with optimized pilot injection timing, Applied Energy, issue.110, pp.201-206, 2013.

J. C. Egúsquiza, S. L. Braga, and C. V. Braga, Performance and gaseous emissions characteristics of a natural gas/diesel dual fuel turbocharged and aftercooled engine, Journal of the Brazilian Society of Mechanical Sciences and Engineering, vol.31, pp.142-150, 2009.

M. M. Abdelaal and A. H. Hegab, Combustion and emission characteristics of a natural gas-fueled diesel engine with EGR, vol.64, pp.301-312, 2012.

L. Sun, Y. Liu, K. Zeng, and R. Yang, Combustion performance and stability of a dual-fuel diesel-natural-gas engine, Proceedings of the Institution of Mechanical Engineers, vol.229, pp.235-246, 2014.

L. Zhou, Y. Liu, C. Wu, and L. Sun, Effect of the diesel injection timing and the pilot quantity on the combustion characteristics and the fine-particle emissions in a micro-diesel pilot-ignited natural-gas engine, Proceedings of the Institution of Mechanical Engineers, Part D: Journal of Automobile Engineering, vol.227, issue.8, pp.1142-1152, 2013.

R. G. Papagiannakis and D. T. Hountalas, Experimental investigation concerning the effect of natural gas percentage on performance and emissions of a DI dual fuel diesel engine, vol.23, pp.353-365, 2003.

R. G. Papagiannakis, D. T. Hountalas, M. S. Lounici, K. Loubar, L. Tarabet et al., Combustion and exhaust emission characteristics of a dual fuel compression ignition engine operated with pilot Diesel fuel and natural gas, Energy, vol.45, issue.18, pp.200-211, 2004.

G. H. Abd-alla, H. A. Soliman, O. A. Badr, A. Rabbo, and M. F. , Effect of pilot fuel quantity on the performance of a dual fuel engine, vol.41, pp.124-131, 2000.

K. Nithyanandan, Y. Gao, H. Wu, and C. Lee, An Optical Investigation of Multiple Diesel Injections in CNG/Diesel Dual-Fuel Combustion in a Light Duty Optical Diesel Engine, 2017.

R. Pettinen, O. Kaario, and M. Larmi, Dual-Fuel Combustion Characterization on Lean Conditions and High Loads, 2017.

N. Dronniou, J. Kashdan, B. Lecointe, and K. Sauve, Optical Investigation of Dual-fuel CNG/Diesel Combustion Strategies to Reduce CO 2 Emissions, SAE International Journal of Engines, vol.7, pp.873-887, 2014.

Y. Zhang, J. Ghandhi, and D. Rothamer, Effects of Fuel Chemistry and Spray Properties on Particulate Size Distributions from Dual-Fuel Combustion Strategies, SAE Int. J. Engines, vol.10, issue.4, pp.1847-1858, 2017.

S. Schlatter, B. Schneider, Y. M. Wright, and K. Boulouchos, N-heptane micro pilot assisted methane combustion in a Rapid Compression Expansion Machine, Fuel, vol.179, pp.339-352, 2016.

S. Schlatter, B. Schneider, Y. Wright, and K. Boulouchos, Experimental Study of Ignition and Combustion Characteristics of a Diesel Pilot Spray in a Lean Premixed Methane/Air Charge using a Rapid Compression Expansion Machine, 2012.

E. Salaun, J. Apeloig, F. Grisch, and C. Yvonnet, Optical Investigation of Ignition Timing and Equivalence Ratio in Dual-Fuel CNG/Diesel Combustion, 2016.

A. Paykani, A. Kakaee, P. Rahnama, and R. D. Reitz, Progress and recent trends in reactivity-controlled compression ignition engines, International Journal of Engine Research, vol.17, issue.5, pp.481-524, 2015.

A. P. Carlucci, D. Laforgia, R. Saracino, and G. Toto, Study of Combustion Development in Methane-Diesel Dual Fuel Engines, Based on the Analysis of In-Cylinder Luminance". 2010, SAE Technical Paper, 1297.

M. Nakamura and H. Ohashi, Study of Diesel Spray Combustion in An Ambient Gas Containing Hydrocarbon Using a Rapid Compression Machine, SAE Technical Paper, vol.980899, 1997.

L. M. Pickett, S. Kook, and T. C. Williams, Visualization of Diesel Spray Penetration, Cool-Flame, Ignition, HighTemperature Combustion, and Soot Formation Using HighSpeed Imaging, SAE Int. J. Engines, vol.2, issue.1, pp.439-459, 2009.

C. A. Idicheria and L. M. Pickett, Soot formation in diesel combustion under high-EGR conditions, 2005.

J. Manin, L. M. Pickett, and S. A. Skeen, Two-Color Diffused Back-Illumination Imaging as a Diagnostic for Time-Resolved Soot Measurements in Reacting Sprays, SAE International Journal of Engines, issue.6, pp.1908-1921, 2013.

F. R. Westlye, K. Penney, A. Ivarsson, and L. M. Pickett, Diffuse back-illumination setup for high temporally resolved extinction imaging, Applied Optics, vol.56, issue.17, pp.5028-5038, 2017.

S. Skeen, J. Manin, L. Pickett, and K. Dalen, Quantitative Spatially Resolved Measurements of Total Radiation in High-Pressure Spray Flames, 2014.

S. Kook and L. M. Pickett, Soot volume fraction and morphology of conventional and surrogate jet fuel sprays at 1000-K and 6.7-MPa ambient conditions, Proceedings of the Combustion Institute, vol.33, pp.2911-2918, 2011.

J. V. Pastor, J. López, J. García, J. M. Pastor, and J. M. , A 1D model for the description of mixing-controlled inert diesel sprays, Fuel, vol.87, issue.13, pp.2871-2885, 2008.

S. Schlatter, B. Schneider, Y. M. Wright, and K. Boulouchos, Comparative Study of Ignition Systems for Lean Burn Gas Engines in an Optically Accessible Rapid Compression Expansion Machine, 2013.

T. Kammermann, J. Koch, Y. M. Wright, and P. Soltic, Generation of Turbulence in a RCEM towards Engine Relevant Conditions for Premixed Combustion Based on CFD and PIV Investigations, SAE International Journal of Engines, vol.10, issue.4, 2017.

S. A. Skeen, J. Manin, and L. M. Pickett, Simultaneous formaldehyde PLIF and high-speed schlieren imaging for ignition visualization in high-pressure spray flames, Proceedings of the Combustion Institute, vol.35, pp.3167-3174, 2015.

M. Bardi, R. Payri, L. M. Malbec, and G. Bruneaux, Engine Combustion Network: Comparison of Spray Development, Vaporization, and Combustion in Different Combustion Vessels, vol.22, pp.807-842, 2012.

L. M. Pickett, Engine Combustion Network, 2013.
URL : https://hal.archives-ouvertes.fr/hal-01701250

M. P. Musculus, Measurements of the Influence of Soot Radiation on In-Cylinder Temperatures and Exhaust NOx in a Heavy-Duty DI Diesel Engine, 2005.

A. G. Gaydon, The Spectroscopy of Flames, 1974.

G. Tautschnig, B. Hampel, C. Hirsch, and T. Sattelmayer, Experimental Investigation of OH* and CH* Chemiluminescence Under Varying Operating Conditions, Combustion, Fuels and Emissions, vol.1, 2013.

W. Hwang, J. Dec, and M. Sjöberg, Spectroscopic and chemical-kinetic analysis of the phases of HCCI autoignition and combustion for single-and two-stage ignition fuels, Combustion and Flame, vol.154, issue.3, pp.387-409, 2008.

A. Iijima and H. Shoji, A Study of HCCI Combustion Characteristics Using Spectroscopic Techniques, 2007.

M. P. Musculus, S. Singh, and R. D. Reitz, Gradient effects on two-color soot optical pyrometry in a heavy-duty DI diesel engine, Combustion and Flame, vol.153, issue.1, pp.216-227, 2008.

J. M. Desantes, J. V. Pastor, J. M. García-oliver, and J. M. Pastor, A 1D model for the description of mixingcontrolled reacting diesel sprays, Combustion and Flame, vol.156, issue.1, pp.234-249, 2009.

J. V. Pastor, R. Payri, J. M. Garcia-oliver, and J. Nerva, Schlieren Measurements of the ECN-Spray A Penetration under Inert and Reacting Conditions, 2012.

J. V. Pastor, J. M. Garcia-oliver, J. M. Pastor, and W. Veratudela, One-Dimensional Diesel Spray Modeling of Multicomponent Fuels, vol.25, pp.485-517, 2015.

H. Schlichting and K. Gersten, Boundary-Layer Theory, 2016.

C. A. Idicheria and L. M. Pickett, Ignition, soot formation, and end-of-combustion transients in diesel combustion under high-EGR conditions, International Journal of Engine Research, vol.12, issue.4, pp.376-392, 2011.

M. P. Musculus and K. Kattke, Entrainment waves in diesel jets, SAE International Journal of Engines, vol.2, pp.1170-1193, 2009.

H. Saito, T. Sakurai, T. Sakonji, and T. Hirashima, Study on lean burn gas engine using pilot oil as the ignition source, 2001.

J. Yeo, J. Rochussen, and P. Kirchen, Application of an In-Cylinder Local Infrared Absorption Fuel Concentration

, Sensor in a Diesel-Ignited Dual-Fuel Engine, 2016.

M. Weissman and S. W. Benson, Mechanism of soot initiation in methane systems, Progress in Energy and Combustion Science, vol.15, issue.4, pp.90016-90022, 1989.

S. M. Sarathy, C. K. Westbrook, M. Mehl, and W. J. Pitz, Comprehensive chemical kinetic modeling of the oxidation of 2-methylalkanes from C7 to C20, Combustion and Flame, vol.158, pp.2338-2357, 2011.
URL : https://hal.archives-ouvertes.fr/hal-02020213

T. Kamimoto, N. Uchida, T. Aizawa, and K. Kondo, Diesel flame imaging and quantitative analysis of incylinder soot oxidation, International Journal of Engine Research, vol.18, pp.422-435, 2016.

S. A. Skeen, J. Manin, K. Dalen, and L. Pickett, Extinction-based imaging of soot processes over a range of diesel operating conditions, 8th US National Combustion Meeting, 2013.

D. Lee and S. Hochgreb, Rapid Compression Machines: Heat Transfer and Suppression of Corner Vortex, Combustion and Flame, vol.114, issue.3, pp.531-545, 1998.

T. Mederer, M. Wensing, and A. Leipertz, GE2-2 LaserInduced Fluorescence to Visualize Gas Mixture Formation in an Optically Accessible Hydrogen Engine(GE: Gas Engine,General Session Papers), The Proceedings of the International symposium on diagnostics and modeling of combustion in internal combustion engines, vol.8, pp.374-379, 2012.