M. Christensen, B. Johansson, and A. Hultqvist, The Effect of Piston Topland Geometry on Emissions of Unburned Hydrocarbons from a Homogeneous Charge Compression Ignition (HCCI) Engine, 2001.

S. M. Aceves, D. L. Flowers, F. Espinoza-loza, J. Martinez-frias, R. W. Dibble et al., Piston-Liner Crevice Geometry Effect on HCCI Combustion by Multi-Zone Analysis, 2002.

J. B. Heywood, Internal Combustion Engine Fundamentals, 1988.

M. Iida, M. Hayashi, D. E. Foster, and J. K. Martin, Characteristics of Homogeneous Charge Compression Ignition (HCCI) Engine Operation for Variations in Compression Ratio, Speed and Intake Temperature while using n-Butane as a Fuel, Trans. ASME, vol.125, pp.472-478, 2003.

S. Kook, C. Bae, P. C. Miles, D. Choi, and L. M. Pickett, The Influence of Charge Dilution and Injection Timing on LowTemperature Diesel Combustion and Emissions, 2005.

S. Kook, C. Bae, P. C. Miles, D. Choi, M. Bergin et al., The Effect of Swirl Ratio and Fuel Injection Parameters on CO Emission and Fuel Conversion Efficiency for HighDilution, Low-Temperature Combustion in an Automotive Diesel Engine, 2006.

J. T. Kashdan, N. Docquier, and G. Bruneaux, Mixture Preparation and Combustion via LIEF and LIF of Combustion Radicals in a Direct-Injection, 2004.

B. Walter and B. Gatellier, Development of the High Power NADI Concept Using Dual Mode Diesel Combustion to Achieve Zero NOx and Particulate Emissions, 2002.

D. L. Siebers, Liquid-Phase Fuel Penetration in Diesel Sprays, 1998.

D. L. Siebers, Scaling Liquid-Phase Fuel Penetration in Diesel Sprays Based on Mixing-Limited Vaporization, SAE technical paper, 1999.

S. Kimura, O. Aoki, Y. Kitahara, and E. Aiyoshizawa, UltraClean Combustion Technology Combining a Low-Temperature and Premixed Combustion Concept For Meeting Future Emissions Standards, 2001.

T. Lachaux and M. P. Musculus, In-Cylinder Unburned Hydrocarbon Visualisation During Low-Temperature Compression-Ignition Engine Combustion Using Formaldehyde PLIF, Proc. 31st Combustion Symp, pp.6-11, 2006.

J. T. Kashdan and J. Papagni, LIF Imaging of AutoIgnition and Combustion in a Direct-Injection Diesel-Fuelled, 2005.

C. Schulz, J. Gronki, and S. Andersson, Multi-Species LaserBased Imaging Measurements in a Diesel Spray, 2004.

G. Bruneaux, Study of the Correlation Between Mixing and Auto-ignition Processes in High Pressure Diesel Jets, SAE technical paper, 2007.

M. Sjöberg, J. E. Dec, A. Babjimopoulos, and D. Assanis, Comparing Enhanced Natural Thermal Stratification against Retarded Combustion Phasing for Smoothing of HCCI HeatRelease Rates, 2004.

J. E. Dec, W. Hwang, and M. Sjöberg, An Investigation of Thermal Stratification in HCCI Engines using Chemiluminescence Imaging, 2006.

E. Stevens and R. Steeper, Piston Wetting in an Optical DISI Engine: Fuel Films, Pool Fires and Soot Generation, 2001.

P. O. Witze and R. M. Green, LIF and Flame-Emission Imaging of Liquid Fuel Films and Pool Fires in an SI Engine During a Simulated Cold Start, 1997.

P. O. Witze and R. M. Green, Comparison of Single and Dual Spray Fuel Injectors During Cold Start of a PFI Spark-Ignition Engine Using Visualization of Liquid Fuel Films and Pool Fires, 2005.

J. E. Dec, A Computational Study of the Effects of Low Fuel Loading and EGR on Heat Release Rates and Combustion Limits in HCCI Engines, 2002.

J. E. Dec and M. Sjöberg, A Parametric Study of HCCI Combustion-The Sources of Emissions at Low Loads and the Effects of GDI Fuel Injection, 2003.

C. D. Marriott and R. D. Reitz, Experimental Investigation of Direct Injection Gasoline for Premixed Compression Ignited Combustion Phasing Control, 2002.